How to Install a Power Attic Vent
Wired and Solar Powered Fans Remove Hot Air and Minimize Toxic Mold
As a caveat, it should be noted that ridge vents with baffles are more effective in using negative air pressure and some power vents incorporate a thermostat and humidistat. Removing humidity from the attic is also important to the health of the home and family; it reduces the chance of mildew and toxic mold.
Home Power VS Solar Power Attic Vents
These are the two types of attic and roof ventilation devices considered in this article. The home powered ones simply tie into an available electrical circuit. Obviously, the solar-powered fans use a small solar panel to power them up.
Two elements to consider are cost of use and the desire to adhere to the green home building concept. Solar energy powered vents are trendy, hip, and planet-friendly. However,
- Solar units are expensive – although the cost has come down, still expect to shell out $200 - $300.
- Home-powered ones cost much less money to operate than they save in utility bills.
- Solar panels only operate while the sun shines.
Determine the Proper Size Fan
Attic vent fans are rated at CFM (Cubic Feet of air moved per Minute). To determine the size for a particular home, first determine the attic's square footage. Remember asking the high school algebra teacher, “Aw, when will we ever really use this stuff?” Well, this is “when.”
Multiply the square footage by 0.7; this will give the CFM fan rating. For example, for a 2000 square foot attic space, 2000 X 0.7 = 1400 CFM.
Locate the Best Vent Position
Heat rises, so the vent should be located close to the roof ridge. Locate the center of the home with respect to left and right. This is approximately where it should be located. Shift it slightly right or left as needed to position it between rafters.
The hole will be cut from the outside of the roof but the rafter location is only visible from the interior. The best way to resolve this little confict is to make a cardboard template of the throat of the vent. With any luck this will be right on the box.
Hold it against the sheathing from underneath (inside the attic) and drive four nails up through the roof (top, bottom, left, and right).
Cut the Vent Installation Hole
Using the nails and the template as a guide, use a utility knife to cut away the shingles and roofing felt.
Hint – Using gloves will save knuckle skin when the knife slips. And it will slip, make no mistake about it!
Now, use a jigsaw or sawzall reciprocating saw to cut out the sheathing.
Note – All cutting can be done with the jigsaw, but the blade will tend to dull quickly, and the heat from the friction on the shingles will melt and load up the teeth with asphalt.
Install the Vent
- Remove the dome from the vent.
- Apply caulk generously to the bottom of the flange.
- Locate the side of the flange that reads “Up”.
- Slip the flange up under the shingles.
- Nail the flange down with roofing nails.
- The “up” side of the flange will be below the shingles, the “down” side will lay on top of the shingles.
- Apply roof cement liberally to all nail heads and anywhere water might make an entrance.
- This is no time to be pretty; it won't be seen from the ground.
- Replace the dome.
- Wire up the fan motor according to manufacturer's instructions and local electrical building codes.
- In most cases, the thermostat should be set on 90 degrees. This will cause the fan to spin at 120 degrees and power down at 90.
Solar Powered Attic Vent
|
What do you think about this article?
More in Home & Style
Latest Articles